You copied the Doc URL to your clipboard.

Condition code suffixes

Instructions that can be conditional have an optional two character condition code suffix.

Condition codes are shown in syntax descriptions as {cond}. The following table shows the condition codes that you can use:

Table 7-1 Condition code suffixes

Suffix Meaning
EQ Equal
NE Not equal
CS Carry set (identical to HS)
HS Unsigned higher or same (identical to CS)
CC Carry clear (identical to LO)
LO Unsigned lower (identical to CC)
MI Minus or negative result
PL Positive or zero result
VS Overflow
VC No overflow
HI Unsigned higher
LS Unsigned lower or same
GE Signed greater than or equal
LT Signed less than
GT Signed greater than
LE Signed less than or equal
AL Always (this is the default)


The meaning of some of these condition codes depends on whether the instruction that last updated the condition flags is a floating-point or integer instruction.