You copied the Doc URL to your clipboard.


Unsigned parallel byte-wise addition.


UADD8{cond} {Rd}, Rn, Rm



is an optional condition code.


is the destination register.

Rm, Rn

are the ARM registers holding the operands.


This instruction performs four unsigned integer additions on the corresponding bytes of the operands and writes the results into the corresponding bytes of the destination. The results are modulo 28. It sets the APSR GE flags.

Register restrictions

You cannot use PC for any operand.

You can use SP in A32 instructions but this is deprecated. You cannot use SP in T32 instructions.

GE flags

This instruction does not affect the N, Z, C, V, or Q flags.

It sets the GE flags in the APSR as follows:


for bits[7:0] of the result.


for bits[15:8] of the result.


for bits[23:16] of the result.


for bits[31:24] of the result.

It sets a GE flag to 1 to indicate that the corresponding result overflowed, generating a carry. This is equivalent to an ADDS instruction setting the C condition flag to 1.

You can use these flags to control a following SEL instruction.


The 32-bit instruction is available in A32 and T32.

For the ARMv7-M architecture, the 32-bit T32 instruction is only available in an ARMv7E-M implementation.

There is no 16-bit version of this instruction in T32.